Настройка Network UPS Tools (NUT 2.0.4)
Добавлено: 2008-03-10 4:40:59
FreeBSD 6.2-RELEASE (GENERIC)
Установил NUT 2.0.4 из пакета.
В ups.conf прописал:
Пробую выполнить
Получаю:
В чём может быть дело? Почему ошибки возникают? Как их можно исправить?
Кабель на COM1 исправный, под widows работает нормально.
Установил NUT 2.0.4 из пакета.
В ups.conf прописал:
Код: Выделить всё
[ups]
driver = bcmxcp
port = /dev/ttyd0 Код: Выделить всё
# ./upsdrvctl start Код: Выделить всё
Network UPS Tools - UPS driver controller 2.0.4
Network UPS Tools - BCMXCP UPS driver 0.10 (2.0.4)
Communications with UPS lost: Error executing command
Communications with UPS lost: Error executing command
Communications with UPS lost: Error executing command
Communications with UPS lost: Receive error (Requested only mode command): 5!!!
Communications with UPS re-established
Connected to UPS on /dev/ttyd0 baudrate: 9600
Model = PW5115 750i 750VA
Firmware = 01.00
Shutdown delay = 120 seconds
Communications with UPS lost: Receive error (Request command): 5!!!
Communications with UPS lost: Receive error (Request command): 5!!!
Communications with UPS lost: Error executing command
Short read from UPS Кабель на COM1 исправный, под widows работает нормально.