Перестают ходить пакеты через интерфейс
Добавлено: 2009-04-24 6:19:07
Столкнулся с такой проблемой: есть шлюз, на котором поднят mpd5.На ней 2а мегабитных интерфейса, один смотрит в одну локалку1(re0),второй в локалку2. Интерфейс, смотрящий в локалку2(re1) поключен к оптике через медиаконвертор. Наблюдается такая картина: когда нет активного трафика на интерфейсе в локалку2, то спустя какое-то время он перестает видеть сеть2, т.е не пингуются ресурсы той сети.Соответственно ни люди,подключающиеся по vpn не видять сеть2, ни сам шлюз не видит сеть2 ,хотя статус интерфейса на тот момент active. Помогает
dmesg.boot
#ifconfig re1
Кто-нибудь сталкивался с таким? как-будто сетевая карта "засыпает" по энергосбережению. Пробывал пускать постоянный пинг с самого шлюза на локалку2 или с виндузовой машины(подключенной по vpn) пинг на локалку2; в этом случает вроде такой проблемы не наблюдается..
Код: Выделить всё
#ifconfig re1 down
#ifconfig re1 up Код: Выделить всё
Copyright (c) 1992-2008 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 7.0-RELEASE #0: Tue Mar 31 11:01:00 MSD 2009
admin@gataway.local:/usr/obj/usr/src/sys/GENERIC
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Intel(R) Celeron(R) CPU 2.80GHz (2793.85-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0xf49 Stepping = 9
Features=0xbfebfbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,SS,HTT,TM,PBE>
Features2=0x651d<SSE3,RSVD2,MON,DS_CPL,TM2,CNXT-ID,CX16,xTPR>
AMD Features=0x20000000<LM>
real memory = 1065287680 (1015 MB)
avail memory = 1028849664 (981 MB)
mptable_probe: MP Config Table has bad signature:
kbd1 at kbdmux0
ath_hal: 0.9.20.3 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, RF5413)
hptrr: HPT RocketRAID controller driver v1.1 (Mar 31 2009 11:00:32)
acpi0: <IntelR AWRDACPI> on motherboard
acpi0: [ITHREAD]
acpi0: Power Button (fixed)
acpi0: reservation of 0, a0000 (3) failed
acpi0: reservation of 100000, 3f6f0000 (3) failed
Timecounter "ACPI-fast" frequency 3579545 Hz quality 1000
acpi_timer0: <24-bit timer at 3.579545MHz> port 0x408-0x40b on acpi0
cpu0: <ACPI CPU> on acpi0
p4tcc0: <CPU Frequency Thermal Control> on cpu0
acpi_button0: <Power Button> on acpi0
acpi_button1: <Sleep Button> on acpi0
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
vgapci0: <VGA-compatible display> port 0xc000-0xc007 mem 0xf0000000-0xf7ffffff,0xfa000000-0xfa07ffff irq 3 at device 2.0 on pci0
agp0: <Intel 82865G (865G GMCH) SVGA controller> on vgapci0
agp0: detected 8060k stolen memory
agp0: aperture size is 128M
uhci0: <Intel 82801EB (ICH5) USB controller USB-A> port 0xb000-0xb01f irq 3 at device 29.0 on pci0
uhci0: [GIANT-LOCKED]
uhci0: [ITHREAD]
usb0: <Intel 82801EB (ICH5) USB controller USB-A> on uhci0
usb0: USB revision 1.0
uhub0: <Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1> on usb0
uhub0: 2 ports with 2 removable, self powered
uhci1: <Intel 82801EB (ICH5) USB controller USB-B> port 0xb400-0xb41f irq 5 at device 29.1 on pci0
uhci1: [GIANT-LOCKED]
uhci1: [ITHREAD]
usb1: <Intel 82801EB (ICH5) USB controller USB-B> on uhci1
usb1: USB revision 1.0
uhub1: <Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1> on usb1
uhub1: 2 ports with 2 removable, self powered
uhci2: <Intel 82801EB (ICH5) USB controller USB-C> port 0xb800-0xb81f irq 11 at device 29.2 on pci0
uhci2: [GIANT-LOCKED]
uhci2: [ITHREAD]
usb2: <Intel 82801EB (ICH5) USB controller USB-C> on uhci2
usb2: USB revision 1.0
uhub2: <Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1> on usb2
uhub2: 2 ports with 2 removable, self powered
uhci3: <Intel 82801EB (ICH5) USB controller USB-D> port 0xbc00-0xbc1f irq 3 at device 29.3 on pci0
uhci3: [GIANT-LOCKED]
uhci3: [ITHREAD]
usb3: <Intel 82801EB (ICH5) USB controller USB-D> on uhci3
usb3: USB revision 1.0
uhub3: <Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1> on usb3
uhub3: 2 ports with 2 removable, self powered
ehci0: <Intel 82801EB/R (ICH5) USB 2.0 controller> mem 0xfa080000-0xfa0803ff irq 9 at device 29.7 on pci0
ehci0: [GIANT-LOCKED]
ehci0: [ITHREAD]
usb4: EHCI version 1.0
usb4: companion controllers, 2 ports each: usb0 usb1 usb2 usb3
usb4: <Intel 82801EB/R (ICH5) USB 2.0 controller> on ehci0
usb4: USB revision 2.0
uhub4: <Intel EHCI root hub, class 9/0, rev 2.00/1.00, addr 1> on usb4
uhub4: 8 ports with 8 removable, self powered
pcib1: <ACPI PCI-PCI bridge> at device 30.0 on pci0
pci1: <ACPI PCI bus> on pcib1
re0: <RealTek 8169SB/8110SB Single-chip Gigabit Ethernet> port 0xa000-0xa0ff mem 0xf9000000-0xf90000ff irq 5 at device 2.0 on pci1
miibus0: <MII bus> on re0
rgephy0: <RTL8169S/8110S/8211B media interface> PHY 1 on miibus0
rgephy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto
re0: Ethernet address: xx:xx:xx:xx:xx:xx
re0: [FILTER]
re1: <RealTek 8169SB/8110SB Single-chip Gigabit Ethernet> port 0xa400-0xa4ff mem 0xf9001000-0xf90010ff irq 10 at device 3.0 on pci1
miibus1: <MII bus> on re1
rgephy1: <RTL8169S/8110S/8211B media interface> PHY 1 on miibus1
rgephy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto
re1: Ethernet address: xx:xx:xx:xx:xx:xx
re1: [FILTER]
isab0: <PCI-ISA bridge> at device 31.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH5 SATA150 controller> port 0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0xf000-0xf00f at device 31.2 on pci0
ata0: <ATA channel 0> on atapci0
ata0: [ITHREAD]
ata1: <ATA channel 1> on atapci0
ata1: [ITHREAD]
pci0: <serial bus, SMBus> at device 31.3 (no driver attached)
acpi_tz0: <Thermal Zone> on acpi0
fdc0: <floppy drive controller> port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on acpi0
fdc0: [FILTER]
sio0: <16550A-compatible COM port> port 0x3f8-0x3ff irq 4 flags 0x10 on acpi0
sio0: type 16550A
sio0: [FILTER]
pmtimer0 on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
kbd0 at atkbd0
atkbd0: [GIANT-LOCKED]
atkbd0: [ITHREAD]
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/9 bytes threshold
ppbus0: <Parallel port bus> on ppc0
ppbus0: [ITHREAD]
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
plip0: <PLIP network interface> on ppbus0
ppc0: [GIANT-LOCKED]
ppc0: [ITHREAD]
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
uhub5: <ALCOR Generic USB Hub, class 9/0, rev 1.10/3.12, addr 2> on uhub1
uhub5: 4 ports with 4 removable, self powered
ukbd0: <vendor 0x3333 product 0x3333, class 0/0, rev 1.10/0.01, addr 3> on uhub5
kbd2 at ukbd0
ums0: <vendor 0x3333 product 0x3333, class 0/0, rev 1.10/0.01, addr 3> on uhub5
ums0: 5 buttons and Z dir.
uhid0: <No brand SP02-A1, class 0/0, rev 1.10/1.00, addr 4> on uhub5
uhid1: <No brand SP02-A1, class 0/0, rev 1.10/1.00, addr 4> on uhub5
uhid1: unexpected endpoint
device_attach: uhid1 attach returned 6
Timecounter "TSC" frequency 2793849996 Hz quality 800
Timecounters tick every 1.000 msec
hptrr: no controller detected.
ad0: 76319MB <Seagate ST380815AS 3.AAC> at ata0-master SATA150
ad2: 76319MB <Seagate ST380815AS 3.AAD> at ata1-master SATA150
GEOM_MIRROR: Device mirror/gm0 launched (2/2).
Trying to mount root from ufs:/dev/mirror/gm0s1a
Код: Выделить всё
re1: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=9b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM>
ether xx:xx:xx:xx:xx:xx
inet xx.xx.xxx.xxx netmask 0xfffff000 broadcast xx.xx.xxx.xxx
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
