Страница 1 из 1

прямое соединение по COM порту

Добавлено: 2009-06-17 0:56:00
mayor
Стоит армейская задача: соединить по COM (прямое соединение компов) 2 машины фря и винда, через модемы Zyxel которые работают по виделеной линии (ноль модем) в винде делаетя без проблем, как FreeBSD соединить с виндой? можна такое замутить или нет, где читать?

Re: прямое соединение по COM порту

Добавлено: 2009-06-17 4:59:42
zg
mayor писал(а):можна такое замутить или нет, где читать?

Код: Выделить всё


    ??????????????? Network interface information required ????????????????
    ? If you are using PPP over a serial device, as opposed to a direct   ?
    ? ethernet connection, then you may first need to dial your Internet  ?
    ? Service Provider using the ppp utility we provide for that purpose. ?
    ? If you're using SLIP over a serial device then the expectation is   ?
    ? that you have a HARDWIRED connection.                               ?
    ?                                                                     ?
    ? You can also install over a parallel port using a special "laplink" ?
    ? cable to another machine running FreeBSD.                           ?
    ? ??????????????????????????????????????????????????????????????????? ?
    ? ?      vr0     VIA VT3043/VT86C100A Rhine PCI Ethernet card       ? ?
    ? ?      plip0   Parallel Port IP (PLIP) peer connection            ? ?
    ? ?      vmnet1  <unknown network interface type>                   ? ?
    ? ?      sl0     SLIP interface on device /dev/cuad0 (COM1)         ? ?
    ? ?      ppp0    PPP interface on device /dev/cuad0 (COM1)          ? ?
    ? ??????????????????????????????????????????????????????????????????? ?
    ???????????????????????????????????????????????????????????????????????
    ?                       [  OK  ]       Cancel                         ?
    ???????????[ Press F1 to read network configuration manual ]???????????


вон аж две сетёвки на COM1, думаю надо рыть либо в сторону sl0, либо ppp0 :roll: