Код: Выделить всё
ip 85.44.0.44 gw 85.44.0.124
ip 85.44.0.66 gw 85.44.0.124
set ipcp ranges local/width remote/width
This command determines what IP addresses mpd will allow to be negotiated at the local and remote ends of the link. For each endpoint, we have a target address and a netmask width. The width determines how flexible we are, i.e., how close the actual negotiated address must be to the target address. A width of 32 means they must match exactly; a width of zero means any address is suitable. For example, 192.168.1.17/25 means that IP address 192.168.1.17 is desired, but any IP address in the range 192.168.1.0 through 192.168.1.128 is acceptable.
By convention, the local address may be 0.0.0.0 to request that the remote server assign us an IP address. Of course, for this to work the remote side must know a priori what our local IP address should be.
The remote address should not be 0.0.0.0. This is so if the peer requests 0.0.0.0, we have some address to give him. The width may of course be zero.
If the two sides cannot agree on the IP address assignments after repeated negotiation attempts, then the connection will fail. This is manifested with the error message ``IPCP: not converging.''
Код: Выделить всё
1: 85.44.0.44 -> 85.44.0.124
2: 85.44.0.66 -> gw
допустим получиться так после замены
1: 85.44.0.44 -> 85.44.0.124
2: 85.44.0.66 -> 85.44.0.111
а как это работать то будет, если фактически gw должен быть 85.44.0.124. пакеты то будут ходить?
завтра попробую на 2 skylink модемах проверить. как оно