Оборудование:
Есть wi-fi адаптер dlink dwa-547
ОС:
#uname -a
FreeBSD flegano 8.2-RELEASE FreeBSD 8.2-RELEASE #0: Fri Feb 18 02:24:46 UTC 2011 root@almeida.cse.buffalo.edu:/usr/obj/usr/src/sys/GENERIC i386
Сетевые устройства:
#ifconfig -a
rl0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=3808<VLAN_MTU,WOL_UCAST,WOL_MCAST,WOL_MAGIC>
ether 00:15:f2:be
37inet 10.10.3.49 netmask 0xfffffffc broadcast 10.10.3.51
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
ath0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 2290
ether 14:d6:4d:08:fd:81
media: IEEE 802.11 Wireless Ethernet autoselect mode 11g
status: associated
plip0: flags=8810<POINTOPOINT,SIMPLEX,MULTICAST> metric 0 mtu 1500
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384
options=3<RXCSUM,TXCSUM>
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x4
inet6 ::1 prefixlen 128
inet 127.0.0.1 netmask 0xff000000
nd6 options=3<PERFORMNUD,ACCEPT_RTADV>
wlan0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
ether 14:d6:4d:08:fd:81
media: IEEE 802.11 Wireless Ethernet autoselect (autoselect)
status: no carrier
ssid sampo.ru channel 9 (2452 MHz 11g)
regdomain ETSI indoor ecm authmode OPEN privacy OFF txpower 20
bmiss 7 scanvalid 60 bgscan bgscanintvl 300 bgscanidle 250 roam:rssi 7
roam:rate 5 protmode CTS wme burst
Конфигурация:
# joe /boot/loader.conf
if_ath_load="YES"
wlan_wep_load="YES"
wlan_ccmp_load="YES"
wlan_tkip_load="YES"
#joe /etc/rc.conf
ifconfig_rl0="DHCP"
#ipv6_enable="YES"
wlans_ath0="wlan0"
ifconfig_wlan0="ssid sampo.ru DHCP"
#dmesg
rl0: Ethernet address: 00:15:f2:be
37rl0: [ITHREAD]
ath0: <Atheros 9280> mem 0xdfff0000-0xdfffffff irq 21 at device 11.0 on pci1
ath0: [ITHREAD]
ath0: AR9280 mac 128.2 RF5133 phy 13.0
wlan0: link state changed to UP
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
wlan0: link state changed to DOWN
wlan0: link state changed to UP
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
ath0: bb hang detected (0x80), reseting
rl0: link state changed to UP
rl0: link state changed to DOWN
wlan0: link state changed to DOWN
wlan0: Ethernet address: 14:d6:4d:08:fd:81
rl0: link state changed to UP
#ifconfig wlan0 up scan
homenetwork f0:7d:68:49:23:d2 6 54M -92:-96 100 EPS HTCAP WPA RSN WME WPS
sampo.ru 1c:af:f7:2d:ed:20 1 54M -92:-96 100 ES WME
Вопрос:
Не могу подсоединится к открытой сети sampo.ru !!!
